




Important Notice: Please double check your Type before ordering.
I have a 10x10 EURMAX Premium C-frame and bought two of these adjusters. They work as advertised. The metal is thick and the adjustment range is decent. My only issue is that the locking mechanism could be a bit more positive. It holds fine under static load, but I'm not sure I would trust it in heavy wind without checking it periodically. For general use on calm days, it's totally fine.
I was about to throw away my old 10x10 EURMAX frame because three legs were different heights after a bend. These adjusters saved it. I set all four corners to the same extended length and now it sits perfectly flat on my uneven patio. The threading is smooth, no cross threading issues. For 20 bucks each, cheaper than a new tent by a lot.
I run a small photography business and use a 10x10 EURMAX as a portable studio outdoors. These adjusters are essential for uneven ground. They let me get the frame perfectly level, which matters for backdrops and lighting stands. The build quality is excellent, and the free shipping was fast. I ordered on a Tuesday and had them by Friday. One of the adjusters had a small burr on the thread, but a quick pass with a file fixed it in under a minute.
Bought a 4 pack for my 10x10 commercial canopy. Works fine but check your leg diameter before ordering. I had to add a thin plastic shim because my poles are slightly undersized. That��s not the product's fault though. Once installed, they hold position well even in 15mph wind. Would be 5 stars if they came with a better installation diagram.
These height adjusters saved my old canopy. One of the legs on my 10x10 frame got bent last year during a windy event, making that corner sit about an inch lower than the others. I almost threw the whole frame away. Then I found these. I put one on the bent leg and one on the opposite corner to balance it out. It took me maybe ten minutes total. The tent sets up flat now and the adjuster holds solid even when I push on the frame. One star off because one of the adjusters had a small burr on the inside thread, but it didn't affect the function after I ran a bolt through it once.
Thanks for subscribing!
This email has been registered!